cushman motor scooters Bargains

Our Featured gas scooters Article



Additionalgas scooters Ideas





Most scooters need a minimum of 100 psi in compression in order to run start and properly. Compression should be checked when the scooter engine is warm. However, that's hard to do if your scooter is not running. So, just hook up a compression gauge and open up the throttle all the way. Crank the scooter until the needle on the compression gauge stops moving. This should take no more than 5 seconds. Very roughly, 100-125 psi is good, 125-150 psi is very good, and 150+ psi is great. If you don't have this level of compression, then you have bad valves and/or bad piston rings. If you want, you can add a teaspoon or so of oil to the engine through the spark plug hole. Then try the compression test again. If compression is higher, then it's likely you have bad rings. The oil will seal the rings and give you better compression. If compression is the same, then you have bad/misadjusted valves.
Got Spark?
Buy an electric 2 wheel scooter today!

More gas scooters Information

Oiling Your Motorcycle Chain - The Easy Way

Thu, 29 May 2008 19:33:25 +0200
If you're anything like me, forgetful in oiling your chain, and when you do, half the oil consumption of your country goes towards lubricating your motorcycle chain, then this is the product for you.



The Cameleon Oiler is an automatic chain oiler that gets installed don your motorcycle. You don't have to do anything, the system oils your motorcycle chain regularly. How cool is that ?

...

Advertisment: .. Motorbiker.org: database of 1,000+ movies with motorcycles in them

Some Serious Army Motorcycle Squad

Fri, 6 Jun 2008 14:15:00 +0200
This looks like quite a serious Army motorcycle squad, equipped with bazookas and all...



Do you think it's effective?? I don't....

...

Advertisment: .. Motorbiker.org: database of 1,000+ movies with motorcycles in them

vespa scooters
¶ 10:20 AM 1 comments